Origamix Rabbit

rkundlarkundla Member, Moderator, Backers, Ultimate Backer
Saw this on another site so I wanted to try it with my Draken. You can find the model by searching the internet for "origamix rabbit".

Configuration:
  • Slot 2
  • MakerJuice G+ Green (first time using it)
  • 30000 ms initial exposure (3 layers) and 9500 ms remaining exposure
  • 1 mm lift, 100 mm/sec rate, 50 mm/sec rate on the return
  • My customized peel (M280 P0 S10 I1 D20)

Notes: 
  • got lots of slag in the resin vat, so it might make sense to dial back some of the times, but I really needed the 30 seconds to get the print to adhere properly
  • Used a base and supports to elevate the rabbit from the plate - some fine detail at the tops of the feet and various other places


image
Ron

Comments

  • rkundlarkundla Member, Moderator, Backers, Ultimate Backer
    I messed up my times. It is 20 secs for the base exposures and 3.5 secs for the layer exposures.
    Ron
Sign In or Register to comment.